Spot Marking

350g aerosol

White Knight Survey and Spot Marking is a quick and easy way to highlight and mark out areas.

Ideal for marking out construction plans, landscaping, identification of hazards and points of reference in temporarily unsafe areas, surveying, sports fields and courts.


  • Safe to spray - CFC and lead free
  • Bright colours
  • Unique upside down nozzle and spray through cap with fully incorporated trigger
  • Quick drying - Touch dry in 10 minutes
  • Suitable for almost any surface

Suitable Surfaces

White Knight Survey and Spot Marking may be used on almost any surface including bitumen, concrete, grass, soil, gravel, plants and timber.

Safety & First Aid

  • This product is highly flammable. Store and use away from heat and eliminate any source of ignition.
  • Soak any clothes used in water immediately after use as they may self ignite.
  • If swallowed, seek medical advice immediately and show the container or label. Do not induce vomiting.
  • If in eyes, immediately flush with running water for at least 15 minutes. Seek immediate medical attention.
  • Avoid breathing vapour or mist.
  • Use only with adequate ventilation.
  • If on skin, remove contaminated clothing. Wash skin thoroughly with soap and water. Do not use solvents or thinners.
  • Warning - Misuse by concentrating and inhaling contents can be harmful or fatal.
For 24 hour medical emergency response in Australia call 1800 807 001 and in New Zealand call 0800 154 666


HIGHLY FLAMMABLE. Keep can away from flame and heat and eliminate any source of ignition. Keep can in a cool place and out of sun. Contents of can under pressure. Do not puncture or incinerate the can, even when empty.


  • Residual paint should be sprayed onto newspaper, allowed to dry and then disposed of via domestic waste collections.
  • Empty aerosol cans are recyclable via steel can recycling programs.
  • Important: Deliberate misuse of this product to damage public or private property is a crime.



  • Cover all necessary areas to protect from overspray.



  1. Shake can vigorously for 1 minute to ensure colour uniformity. Shake can occasionally during use.
  2. Place and use the can in the inverted position.


  1. Hold the can upright approximately 25cm from the surface.
  2. Depress valve firmly. For best results use steady, even strokes.


Touch dry in 10 minutes. Re-coat after 1 hour. Drying will be slower in cold or humid conditions, in the absence of ventilation or where heavy film builds are applied.

Clean Up

Overspray can be removed while still wet with mineral turps.

Spot Marking
Safe to Spray