White Knight® Bench Top Protective Coating

1L

White Knight® Bench Top Protective Coating is a hard wearing clear coating that delivers a tough protective coating over painted laminate bench tops.



Features

• Tough, protective clear coating

• Hard wearing

• Low sheen

White Knight ® Bench Top Protective Coating can be applied over laminate bench tops that have been painted with White Knight Laminate Paint.

Interior use only.

 

1. PREPARATION

  • Thoroughly clean surface with white Knight Tile & Laminate cleaner following label directions.
  • Prime surface with White Knight Tile & Laminate primer following label directions
  • Paint surface with White Knight Laminate Paint following label directions.
  • Allow surface to dry for 24-48 hours before applying White Knight Bench Top Protective Coating. If allowed to dry for more than 48 hours, lightly sand before product application.
  • Ensure surface is clean, dry and free from dust, dirt, grease, polish and other contaminants.

2. APPLICATION

  • Stir Part A thoroughly with a broad, flat stirrer in a circular lifting motion.
  • Add Part B. Mixing ratio is 3 Part A: 1 Part B by volume. IMPORATNT- incorrect mixing ratios will result in coating failure. Stir for 5 minutes.
  • Apply coat with a foam  Do not spray. Lay off evenly for a consistent finish.
  • After mixing, the product life is 1 hour maximum. Do not use product after pot life has been exceeded.

DO NOT USE AT TEMPRETURES BELOW 10°C OR ABOVE 35°C OR IN HIGH HUMIDITY.

Do not apply to damp surfaces or when rain is imminent as moisture contamination will prevent the curing process resulting in a soft finish.

3. COVERAGE

Approximately 20m² per litre per coat, depending on the nature of the surface

4. CLEAN UP

Clean equipment with water immediately after use.

5. CARE & MAINTENANCE

Bench tops coated with White Knight Bench Top Protective Coating can be cleaned with mild, non-abrasive household cleaners. Avoid use of abrasive cleaning products which can damage the finish.

6. SAFETY & FIRST AID

KEEP OUT OF REACH OF CHILDREN

  • If swallowed do not induce vomiting. Wash out mouth thoroughly with water. If symptoms develop seek medical attention.
  • If in eyes, hold eyelids apart and flush eyes continuously with running water. If symptoms develop and persist seek medical attention.
  • Do not breathe vapour. If inhaled, remove affected person from area. If symptoms persist seek medical attention.
  • If on skin, wash affected area thoroughly with soap and water. If symptoms develop seek medical attention.
  • Ensure adequate ventilation during use and whilst drying.

For advice, contact Poisons Information Centre (Australia 131 126; New Zealand 0800 764 766) or a doctor

Caution:

DO NOT RESEAL THE CONTAINER ONCE PART A HAS BEEN MIXED WITH PART B.

7. ENVIRONMENT

  • Do not pour unwanted paint down the drain.
  • Keep unwanted paint in sealed containers for disposal via chemical waste collections. Solidified catalyzed paint may be disposed of a non-hazardous solid waste.
  • Empty paint containers should be left open in a well ventilated area to dry out. When dry, recycle steel containers via steel recycling programs.
  • Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check your local council first.

 

Need Help?

It’s as easy as selecting a project type and the material involved